Open every day 7am–11pm · Reply within 30 minutes

24 allée du Barrois, 31770 Colomiers

PC build mistakes: 10 traps to avoid

PC build mistakes: RAM in the wrong slots, missing CPU power cable, cooler film left on, XMP off… 10 traps to avoid and how to fix them. Read the guide.

Lire en français : Erreurs de montage PC : 10 pièges à éviter · Leer en español: Errores al montar un PC

The most common PC build mistakes are easy to avoid: memory in the wrong slots, a forgotten CPU power cable, the plastic film left under the cooler or a memory profile never turned on. Here are the 10 traps I fix most often at my Colomiers workshop, near Toulouse.

Before you start

1. Not checking compatibility

The processor must match the motherboard socket, and the memory must be the right type (DDR4 or DDR5). Also check graphics card length and cooler height against the case.

2. An undersized power supply

A weak or poor-quality PSU causes reboots in games or worse. Choose a reputable brand with headroom over your graphics card and CPU draw, and the right connector for recent cards.

3. Skipping a test outside the case

A quick first boot on the motherboard box, with CPU, one memory stick and cooler, catches a faulty part before everything is wired.

During the build

4. Forgetting the CPU power cable

The 8-pin « CPU » cable at the top left of the board. Without it, no boot, or fans spinning with no display.

5. Memory in the wrong slots

With two sticks on a four-slot board, slots 2 and 4 (A2 and B2) are almost always the right ones for dual channel. Check the manual.

6. Leaving the film on the cooler

The cooler base often has a clear protective film. Leave it on and the CPU overheats within minutes. At the workshop I use Thermal Grizzly Kryonaut thermal paste.

7. Plugging the monitor into the motherboard

With an NVIDIA RTX or AMD Radeon card, plug the monitor into the graphics card.

8. Missing or extra standoffs

A misplaced standoff can touch the board and cause a short circuit.

After the build

9. Not enabling XMP or EXPO

Memory often runs below its rated speed by default. Enable XMP (Intel) or EXPO (AMD) in the BIOS, then check stability.

10. No stability testing

Booting is not the same as stable. I run OCCT stability tests (CPU, memory, GPU, power supply) and watch temperatures before handing a PC back.

What I do for you in Colomiers and Toulouse

Custom PC builds: you buy the parts with no markup from me, I charge for the build, with a 2-year warranty on the build and stability tests. I also check PCs you built yourself, and help you pick parts (PC advice). Free quote, free travel within 10 km of Colomiers (Toulouse, Blagnac, Léguevin), open every day 7 am to 11 pm by appointment.

FAQ

Why won’t my new PC turn on?

Check the PSU switch, the 24-pin and 8-pin cables, memory seating and the case power button cable.

Fans spin but no display after building?

Plug the monitor into the graphics card, test with one memory stick and look at the motherboard debug LEDs if it has any.

Should I update the BIOS after building?

Often recommended with a recent CPU. Follow the board maker’s procedure and never cut power during the update.

Planning a custom PC or stuck on a build? Call me on +33 6 13 64 08 48 or use the contact page.

Computer problem? Let’s talk.

Describe your problem or project. I reply within 30 minutes with a clear, free quote. Every day, 7am to 11pm.